sensor

This sensor is screwed into the upper intake manifold. It measures the temperature of the air going into the engine.

This is the Mass Air Flow Sensor with the air filter box.

Still sorting out small mechanical bits on my 88 B-II. For as long as I haveowned this one it has run really cool; needle down near the bottom of the "normal" range. Then it stopped reading altogether. When I changed the sensor it began reading in the center of the gauge, which suggests that it...

Before I even spend $20 I'd like to check my rear abs sensor. Any idea on what range it should read on an ohm meter? Front ones too if you've got that info. But both front read the same.97 xlt awd 5.0L

I have a 1994 Ford Ranger XL, 2.2 liter engine. The engine temperature guage on the instrument cluster works only a little -- it raises (about 1/2") but not past the warm section. The engine gets hot, and I've installed a new thermostat 8 -10 months ago. I've owned the truck for about a...

...and "How To Swap a MAP Sensor" ...The 91's do in fact have a MAP sensor...(Manifold Atmospheric Pressure)...and I've got proof...:biggthump ...I've been working on another code (code 85) so I can pass smog and I thought I had it fixed until, I pulled out a code 22 from nowhere...

I have a 2nd gen Explorer and I have a question about the brakes and ABS system. Would the ABS light being on, be directly associated with decreased braking power? The Fliud lines are good, The pads and calipers are good and the rotors are good. My mechanic wants me to replace all the ABS...

My 95 explorers speedometer jumps all around and some times doesnt work at all, overdrive lights flashes but not all the time, jumps in and out of overdrive and sometimes doesnt shift right, Ammco had a free tranny chck and said the codes came back speed sensor, I replced it myself, not hard at...

my x has been having a plethera of idle/sensor issues lately and one of them is the ETC sensor. i found the thing but im having a hard time reaching it, and im not trying to take off the intake manifold or anything like that. any suggestions on a good approach?

i recently have been getting 3 trouble codes; only one of which is a legitimate one: p1131 - o2 sensor bank lean p0000 p0000 there is hesitation during idle and across all speed ranges (particularly @ highway speeds). using my ScanGauge II I was able to view the o2 sensor readings and its...

:confused: I have replied to a few post. But never asked a question myself. I can't seem to find the answer to this one. Although I am sure it is on here somewhere else. I have an overhead console, that recently burnt out(but that is a different story, unless you have one for sale...