tail

I recently saw these taillights listed on eBay and decided to give them a try as I doubt anyone will ever make full LED taillight assemblies for second gen explorers. These taillights still use bulbs but the lens makes it look like an LED assembly. Running light: Brake light: Side...

So i recently reconnected my multi function switch, and when i tested the signals, the right rear tail light quit working, i replaced the bulb with a brand new one and nothing. all the other signals work, and it doesnt speed up at all either so im really not sure what it could be. I need to get...

I tried replacing the bulbs in my rear brake lights for leds. At first they worked properly but after a while they over heated and burned out. Could i add a resistor for when i hit the brake? Is there a fix for this or what? I already installed the reverse lights and Flashers with resistors...

My first time with bondo, and welding. what do ya think? before: 2011-07-14_17-17-47_103 by Justinsdiy, on Flickr After: 2011-08-25_19-46-07_434 by Justinsdiy, on Flickr here are some pics of when it was being done: 2011-08-20_15-03-32_653 by Justinsdiy, on Flickr...

Hi all on the Forum! So...I just got pulled over by a hard @** cop, and he said my tail lights are illegal because they aren't DOT approved. I see his point becuase they don't say anywhere on the housing that they are DOT approved. He said they can be smoked, but since they don't say "DOT"...

Can someone please tell me which fuse I need to replace to make my tail lights work again. A wire diagram would be much appreciated. I have a 2002 XLT.

Body lift w/ 32s, showing altezzas and bumper gap (brfore new custom brackets)

Check out my smoked tails!! Did them myself!

These are my TYC Gunmetal Grey Alteezas that I got when someone busted one of my stock tail lights at school.