For Sale - 03 Explorer xls V6 ENGINE FULLY BUILT | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

For Sale 03 Explorer xls V6 ENGINE FULLY BUILT

Joined
January 29, 2014
Messages
11
Reaction score
0
City, State
Haverford, PA
Year, Model & Trim Level
2003 Explorer xls
hey guys, so its come to an end for me and my explorer time to throw in the towel
so up for grabs is the engine thats been reworked it was bored .20 over new all timing chains and guide replaced pistons/rings, seals, bearings, valves and springs replaced and new valve seats were cut comes with all wires and sensors and new E3 spark plugs and high flow headers bigger fuel injectors, upgraded coil pack and wires engine just needs a 1000 mile break in and your good to go it should push close to 350hp if not a little bit more with a tune and intake/exhaust
this engine is built better then when it came off the factory line!! the shop also backs the engine by a 3year warranty
engine is black and red

this engine is ready to drop in 100% complete -----------$5400$
CALL OR TEXT if you have questions
Thanks,
Stockton M.
 



Join the Elite Explorers for $20 each year.
Elite Explorer members see no advertisements, no banner ads, no double underlined links,.
Add an avatar, upload photo attachments, and more!
.





What does the buyer need to do to make sure the warranty transfers to them when they buy it?
 






the warranty should just carry over since all the warranty covers is the build of the engine
 






unrealistic claim

Claiming 350 or more bhp for the modifications listed seems excessive. The stock bhp was 205. A 0.20 inch (5.08 mm) overbore increases the bore from 3.953 in. to 4.153 in. The cylinder walls at the thinnest section are only about 5 mm thick. Were sleeves installed? The overbore increases the displacement from 243.7 cu. in. to 269 cu. in. for maybe an increase of 25 bhp because of increased valve relief and displacement. What is the new compression ratio? New valves won't increase hp unless they are larger in diameter. Even Supersix Motorsports' stage 2+ heads only added 30 bhp with the stock cam. The stock exhaust manifolds are decent so headers might gain 10 bhp. Realistically, for what you've listed I estimate your power to be around 240 to 250 bhp with a potential of 275 with a custom tune.
 












Engine

More information on the engine please.
 






Back
Top