lynnboy021
Well-Known Member
- Joined
- January 17, 2010
- Messages
- 263
- Reaction score
- 15
- City, State
- billerica ma
- Year, Model & Trim Level
- 2004 explorer
so i just rebuilt my tranny and i just finshed but i had a big or small problem. i went to start up the truck to let the tranny and motor warm up and i hard a pop so i turn off the motor and there was tranny fluid on the floor. i thought i did not hook up the lines but i did so i looked at the servos and the left servo poped out cuz i dont think i installed the snap ring good. so my ? is do i have to remove the tranny and open it up or can i just install the servo piston back in???? i saw here that someone that builds them installed one in his truck with the tranny still in the truck and he also bored the servo too. so i must be ok right?