in the middle of installing lift! help

[metstalker]

i have a first generation and the everything has gone fine but now that i am putting the steering extension on the part that goes into the lower part of the steering shaft is suppose to have a indention on the top but it does not what could i use to make an indention?

any help would be appreciated

 

[IZwack]

I'm not exactly sure if I read your post right but I kinda had the same problem when I put a Body Lift on. The extension piece just would not slip into the bottom end of the steering shaft. What I did was removed some more of the flat part away with a grinder. The easiest way to get at it was through the wheel well - just be carefull with the grinder - dont cut/grind anything else away.

 

[metstalker]

thanks zwack i finally fixed the problem but that Performance Accesories kit isnt worth a dam when it come to bumper brackets i had the hardest time with the front ones and all the holes were a 1\4 inch off