I hope you all know this is just Jon's "get off my ass and do something" thread.
I move slow. James has been a great motivator.
Anyway-My new wideband has just arrived!
The box is opened. I had to make a phone call to discuss a much needed vacation and the guy kept me on the phone for hours, rambling on and on about
Navajo' ****** blown away by turban's?
By the time it was all over it started making sense, so I said-"Hey I'm going to go get this wideband on here, you go ahead and book that canoe!"
Just then the temperature dropped from about 40 degrees-straight down to snowing.
I have a fire lit in the stove, hopefully it will be warm out there by the time you motivate me to go install this thing.
OK
topic for discussion-
How would you route your wideband sensor cable?
I had used the transmission tunnel access panel-but this involves removing the console-4406 shifter ring and access panel.
I don't think the wideband install is intended to be permanent. Once the tuning is finished for this set up I remove it anyway
The connectors are too large to even think about going through the firewall
I'm using the downstream o2 sensor hole for bank 1-right down through the console access panel.
I think I will just go out the door and around the running board since it's coming back out anyway-
Thoughts?