Media added by BrooklynBay | Ford Explorer Forums - Serious Explorations
  • Performance Upgrades - Maintenance - Modifications - Problem Solving - Off-Road - Street Trucks.
    Covering the Explorer, ST, Sport, Lincoln Aviator, Sport Trac,
    Mercury Mountaineer, Mazda Navajo, Ford Ranger, Mazda Pickups, and the Aerostar.
    Featuring H.I. - Human Intelligence.

    Register Today It's free!

Media added by BrooklynBay

The power steering pump.

The power steering pump.

  • 0
  • 0
The front seal blew out.

The front seal blew out.

  • 0
  • 0
The front pulley is being removed.

The front pulley is being removed.

  • 0
  • 0
Power steering & transmission filters.

Power steering & transmission filters.

  • 0
  • 0
OTC 7005 installation tool.

OTC 7005 installation tool.

  • 0
  • 0
Hold the outer wrench while tightening the inner nut.

Hold the outer wrench while tightening the inner nut.

  • 0
  • 1
Always use a special tool to remove the hose.

Always use a special tool to remove the hose.

  • 0
  • 0
LED circuit schematic diagram.

LED circuit schematic diagram.

  • 0
  • 0
The top housing is off.

The top housing is off.

  • 0
  • 0
The second bolt is a little harder to reach.

The second bolt is a little harder to reach.

  • 0
  • 0
The first bolt is coming out.

The first bolt is coming out.

  • 0
  • 0
Performance thermostat with a special gasket.

Performance thermostat with a special gasket.

  • 0
  • 0
The utility pump is completed.

The utility pump is completed.

  • 0
  • 0
The outlet hose is inside the bucket.

The outlet hose is inside the bucket.

  • 0
  • 0
Ryobi flashlight is hacked.

Ryobi flashlight is hacked.

  • 0
  • 0
Rubber washers are used as spacers.

Rubber washers are used as spacers.

  • 0
  • 0
Parts for the cordless utility pump.

Parts for the cordless utility pump.

  • 0
  • 0
The replacement thermal fuse is in the housing.

The replacement thermal fuse is in the housing.

  • 0
  • 0
Use a clip on heat sink when soldering a thermal fuse.

Use a clip on heat sink when soldering a thermal fuse.

  • 0
  • 0
The thermal fuse is pulled out of the housing.

The thermal fuse is pulled out of the housing.

  • 0
  • 0
The thermal fuse.

The thermal fuse.

  • 0
  • 0
The housing is removed to expose the 15 Ohm resistor & thermal fuse.

The housing is removed to expose the 15 Ohm resistor & thermal fuse.

  • 0
  • 0
The case is removed from the SRS module.

The case is removed from the SRS module.

  • 0
  • 0
The SRS module is on the left, and the chime module is on the right.

The SRS module is on the left, and the chime module is on the right.

  • 0
  • 0
Back
Top