The #1 Ford Explorer enthusiast resource for over 25 years!
Performance upgrades, maintenance, modifications and problem solving. Covering the Explorer, ST, Ecoboost, Lincoln Aviator, Sport Trac, Mercury Mountaineer, Mazda Navajo, Ford Ranger, Mazda Pickups, and the Aerostar.
I understand that the camber kit will do the job. I have them, they work great. The question stands. Will a passenger side 2 piece uca work on the drivers side. I think I read that the low rider boys do this?
I will check pin 19. Is that the gry/blk wire circuit 679?
I used the abs module and transducer sensor(mercury switch)
yes 99 pcm, but from mountaineer.
03 f150 manual stick shift trans
Tack works fine after moving one wire over
Thx for the intrest.
no abs faults
dont have cruise or message center
truck has aftermarket radio
Took it to dealer only thing they could tell me when it was data logged was speed abs output was correct but no vss signal. It does have a check engine light which i think is a p0500? I...
My truck is a o1 sport. It's 2wd 2dr manual Trans. I swapped in a 99 5.0 with an 03 f150 Trans. The truck runs great but for the life of me of me I can not figure out the speedo. I wired in the abs parts from the donor. Still nothing. I'm at the point , I will pay someone to help me.
"I separated the VSS signal at the main engine harness as the 96 EEC wants the transfer case signal and the rest of the car wants the signal from the ABS system."
"The 2001 harness does not have a ground run for the VSS. The hole is blank. I grounded the correct wire and all errors gone...
My truck is a 01 sport 2wd 5 speed. Getting ready for the 5.0 swap. Donor truck is 00 mounty awd 5.0. This is what I have found.
98-03 4.2 f150 2wd trans
96 5.0 f150:
clutch, flywheel, starter, and backing plate
Reflash to loose trans codes (Henson, or dirty dirty racing)...