Search results | Ford Explorer - Ford Ranger Forums - Serious Explorations
  • Register Today It's free!

Search results

  1. Dumple

    289 np435

    OK i know that a 302 and 5 speed is going to be a better option but im getting my hands on a 289 for $free.99 and i can find an np435 for cheap too. My question is does anyone currently run a small block in the 1st gen b2/ranger? Im sure i could figure out getting the 289 in there just fine but...
  2. Dumple

    Bronco ii 4.0 tach

    I recently picked up an 88 bronco ii that the P.O. swapped a 4.0 into. It was a pretty clean swap and everything is working like it should, except for the tach. It reads about 1300 at idle. It is idling at a normal spot it's just the tach is off. The tach rises and falls with the engine just...
  3. Dumple

    dana 44 hp

    I just picked up 2 dana 44 High pinions and ive got a question. They both need some parts rebuilt on it. The one has a problem with the pinion not engaging on the ring and the other is missing the passenger side axle shaft and has drum brakes. So my question is can I take D44 ttb parts and slap...
  4. Dumple

    EB dana 30

    Sp I picked up a 66-77 bronco dana 30 for $free.99 and it's got most of the goodies there. Radius arms, coils, steering... but it needs an axle shaft and everything from the steering knuckles out. My biggest question is can I use xj d30 parts and slap them on my EB d30? This will be going under...
  5. Dumple

    drop pitman arm

    So I went and bought a rough country 4 inch lift for a ranger knowing that I'd be doing a SOA in the rear. Well everything turned out great, except for one thing. The pitman arm. The one that came in the kit rear f150/bronco on the side so I was skeptical. But being just ready to wheel I slapped...
  6. Dumple

    auto to manual hub question

    After finishing my lift I made a mistake. So my origional axles came with an open rear diff and 3.27 gears. Lame. So I bought a parts truck for a song and it came with 3.73s and a limited slip rear end. So I swapped them over while lifting the truck and did a pretty nice soa swap. Well me...
  7. Dumple

    Rhino lined floor plan questions

    Hey, guys, so ive been doing some pipe dreaming. Who here has rhino lined the entire floor plan of their daily driver? Is there a big difference in noise? How does it fair in the winter, does it make it a lot colder in the cab now? And also how much does it cost for front to back? If youve got...
  8. Dumple

    99 5.0 questions

    Hey, Gurus, I might have an opportunity to pick up a 99 ex with a 5.0 in it for cheap. Are these 5.0s roller motors? and is this a pretty straight foward(for the most part) swap into a first gen explorer? And what manual trans/t-case would you recommend for the swap? Thanks in advance.
  9. Dumple

    jeep xj bumpers on a real suv

    So I recently joined the explorer fan club and bought my first x 3 months ago. First off its a 92, xl, 4.0 ohv, 5 speed, 4 door and 4x4. This truck has the option of power nothing and I love it. When I bought it the ladies said that the tires needed replaced and they just didn't have the time or...
Top