Search results

I just got a check engine light that came on and went to autzone to have it read. They said it was the transmission. So I took it to my car repair center and they scanned the tranny and came out with this . Codes P1762-SSC/SS3, SSD/SS4 OD Band Failure Transmission slips through second gear...

I currently have a 1992 4WD Explorer 4.0L, but of course it has the rusted out really bad, I am looking at getting a 1993 or 1994 that has a motor that is shot so I can get it real cheap. My engine in my 1992 is brand new, will it work with a 93 or 94?

Will do, I will order one up tomorrow. Thanks I will let you know if that worked!

Here is my dilema, My car is fine at first for about 10 mins and my gauge starts climbing and goes past the H and my Check Gauge light comes on, and then it drops back down to normal, and will start climbing again but not as high as the H. Anyone know what causes it? This is on my 1998 Eddie Bauer

When I switch my auto lamp on it keeps the headlights on no matter if it is day or night. Any ideas why this would be happening?

Ok, today, the truck started for like 5 seconds then died, could the engine be flooded?

Ok, here is the deal. I have the a/c compressor off my X right now, so I have the belt on without the a/c compressor. I noticed that the fuse was blown for the eec relay. So I replaced the fuse and tried to start it up again, and the fuse blew again. So I blew out the fuse box and put a new...

Yes, it sure was.

Is that what usually makes that noise when you turn the key. I know the pump is a couple months old. I will check it.

I had started my car and had it idling for a couple minutes because I was on the phone, then it died. I go to start up the engine again, and it justs cranks but won't turn over. I also notice that when I turn my key and you usually hear a whineing noise, like a motor or solenoid turning on. I...

Yeah, I guess. I don't like them being on all the time. Where can I get a conversion kit.

I just purchased a 98 X, and my headlights stay on all the time while driving, even if it is day or night. I have the headlight switch turned off. Any advice? I only want autolamps....

No, I wish I did. I am going to check my vacuum lines later today, and see if something came loose.

Cleaned out the MAF and installed new IAC, no change really, has a very rough idle. If I unplug the maf, it still runs rough.

I am going to change out the IAC tonight. I will let you know.

What Is The Fprc?

Ok, any suggestions from here?

Ok here is the problem. If I start my engine the car starts for like a second and dies immediately. But if I quickly put it into drive and keep on the gas the car will not die. I will be rough while driving but will get me back home. But if I come to a stop I need to press the gas a bit to...

is there any particular color caibration tube I should get from C&L?

I never got any reply, does somebody have a link so i can purchase this bamachip.?

Any specific year I should look for on a Cobra?

I put my stock maf sensor on my new 73mm c&l maf unit, and I think that something is not right here. Am I supposed to get my maf configured for my bigger injectors, and cold air intake, supercharger and such?

Thanks, I sent them an email to see what my options are.

I have a Supercharger, C&L MAF, BBK 66mm Throttle Body, 24# injectors. Can somebody recommend the best chip I can get for my 1992 X?

I am looking for a performance MAF for my 92X anyone got any ideas and/or links?