Search results

Thanks for the write-up. Quick question. My 95 Exp XL with 195k makes a humming sound above 20mph. There are no clicks or grinds. Steering seems tighter than I remember. Could the cv joints be making this noise and how do I check? Thanks.

I followed your post for removing the cv joints in preparation for rebuilding the front differential. My 95 stock Exp with 195k is making noise (no clunks, grinds, just a howl). Are the cv joints a possible source, and if so how can I check them. Tks.

AFTER REPLACING THE UPPER AND LOWER INTAKE MANIFOLD GASKETS, I FOUND THAT I HAD NOT CORRECTLY INSERTED THE EGR TUBE BACK INTO THE INTAKE MANIFOLD. I HAD A MASSIVE VACUUM LEAK. THE ENGINE WOULD ONLY RUN AT HIGHER RPM AND DIED WHENEVER THE THROTTLE WAS BACKED OFF. I HAVE TEMPORARILLY BLOCKED THE...

I have a 95 Ford exp 4wd second gen. Need to know how to check and how to change the fluid in the front axle. :salute:

My selector was set to 2wd. When I removed the shift motor the xfer case stub was almost, but not quite in 4wd position. I have since confirmed that when I manually turn the stub to 4wd and then change the selector to 4wd, that the front axle engages normally. I can manually change the stub...

My 95 Explorer 4wd stopped working during the winter. I missed the small print on derocha's post (91-94)and rebuilt the shifter motor. There was a small crack on the plastic limiting wheel, which I attempted to repair with 3/8" inch shrink tubing. The shift selector was in 4H position and...

2nd gen 4wd not working Thanks to GIjoecam for your article. I have a 95 4wd v6 automatic with the switch 2wd, 4auto, 4low. I followed your directions for safety stands - have all 4 wheels off the floor. With the engine running and in neutral, the switch light comes on for 4auto and...

Please explain a little more about moving the spring mechanism in the hub. The only opening I see is where the ABS sensor came out and the screw hole that held the sensor in place.

rough idle The posts for locating and correcting a rough idle problem were very helpful. I went through all of the posts related to sensor cleaning.:thumbsup: When I started to work on the problem, liquid would splash out of a drink sitting in the center console cup holders.:( Each...