Search results | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

Search results

  1. G

    Water in Spark Plug Well (#8)

    I also used dilectric grease on the boots around the well seal, boot to plug interface, and cop to boot interface. Hope this helps. After the storms yesterday there was no water seen. GP
  2. G

    Water in Spark Plug Well (#8)

    First I thought I could rip a piece of pvc pipe down and get it in there. Couldn’t keep it in place. I had a 24” section of vent pipe in the basement. I kind of cut it down to fit over the back of the engine. The drips should roll off the back. It is zip tied to the hoses, wire loom at the...
  3. G

    Water in Spark Plug Well (#8)

    Any good tutorials on putting a gutter under the cowl clips to stop the water from leaking down into the plug well? I tried aluminum tape because I had some. It rained last night and there was some water in top of #8 COP again. It didn’t run down into the well yet though. Options 1. Gutter...
  4. G

    Spark Plugs

    update- all 8 plugs are out. Used the beam type torque wrench to monitor the torque and never went over ~28lb-ft. I will install the new ones tomorrow morning and replace all of the boots/springs. Any tips on fixing the water leak through the cowl? I’ve seen a gutter, rtv at cowl, aluminum...
  5. G

    Spark Plugs

    My sons 06 had a miss about a month ago. It has 135k on it with what I believe are probably original plugs. Code was Cylinder 8 misfire. I didn’t have time to do the plugs so I got a new coil. There was moisture in the well when I changed it. This evening I started taking coils off to be...
Back
Top