Search results

Just wrapping this post up. I have been to busy to do any of the testing mentioned above but I have solved the problem, although it may be temporary, time will tell. The history of the explorer is unknown but it had HF radio antennas and Anderson plug which tells me it has done a lot of towing...

Very Interesting. I think I will run a wire up to the dash and install a 0 -100k pot. At 0 the sensor will be as is, if I wind the pot up the PCM will think the oil is cooler than what it is. A post a reply on what I have found. Allow me a couple of months. Thanks Imp.

Excellent info Imp, thanks a lot. I will be getting my head into this soon when I can get some spare time, however would like to know a bit about the temp sensor, and perhaps away to fudge it. Like put a resistor or something in the circuit. Any info about measuring the temp sensor welcome.

hi Brooklyn Bay. Please have a look in this thread. http://www.explorerforum.com/forums/showthread.php?t=394158 I am trying to get info on how the computer knows when to send the 12volt output to the TCC solenoid. I feel an input is faulty and the fault is power related. This is at speeds...

Rickvo, did you ever pinpoint the reason for the TCC not locking up. I have a similar problem where the TCC solenoid is not getting its voltage. Any feedback welcome

What was the fix ? Hi Dorin overhauling the torque converter clutch would have fixed your trans alarm, but were you able to establish the reason for the clutch to fail? I have a similar problem. My problem is the TCC solenoid is not getting told to operate, which causes the clutch to burn...

Greetings, seeking info on how to test the Transmission Fluid Sensor to see if it is recording a proper temperature reading. The schematic shows that it it is in the transmission. Is the TFT sensor accessible or transmission has to be stripped? How would you test it, assuming it is a few...

pcm OR ccm ? Thanks IMP, much obliged. Have alook at Sparkys post http://www.explorerforum.com/forums/showthread.php?t=148433 scroll down to CCM. Sparky says that the CCM outputs to the TCC solenid. He also has posted about the PCM if you scroll further down. Is this CCM part of the...

IMP's message Thanks. IMP. what you said is all good and agreed, the problem is that the solenoid is not being told to lock. The 1000 RPM difference between 4th and 5th is at 100 -110kph (68mph) which is our highway speed in Australia. I am looking for feedback on sensors. It appears the...

This 2005 V6 explorer has only done 60000 K, and has burnt out the TCC 3 times. Apparently 2 times with the previous owner (unknown to me) and once with me. On learning that this was the 3rd time, I paid for investigation trouble shooting by a reputable trans specialist, but came to a dead...

tcc 1744 Dorin, i would like to now what ended up fixing this problem. thanks