Search results

311,x.. on my 99 XLT, had transmission repaired at 280,000 (broke reverse band) replaced; ball joints, head gasket (because on a coolant leak), O2 sensors, rear struts, alternator, radiator (twice), water pump, thermostat(twice), Axle seals, front wheel bearings, EGR Differential pressure...

I have the same setup for a HU only. My problem is with keeping the HU in. If I it a bump or accelerate too fast the HU pops out. Any suggestions on a better bracket for a HU.

wheel bearing or tie rod could be the cause. Greasing the ball joint only allows the ball joint to absorb vibration better.

free fix, almost Try swapping the downstream O2 sensors with the upstream O2 sensors. The down stream sensors are not used for engine control, and they are in a less harse environment than the unstream sensors. Swapping the sensors will buy you at least a few mounths of time. To remove the...

I have a 99 xlt which had that same whining noise in warm temperature. The noise went away after I replaced the Head gasket which required me to replace the intake manifold gasket. Extra air gets into the enging through the leaking gasket. This air is unmetered since it bypasses the Mass air...