Search results

Here is a diagram of the Wire Tap LOC Install method... BTW what stock setup do you have (is there a stock sub). If you try to use the stock remote on, you may run into a low voltage remote on situation (ie <5 vdc) which will keep your aftermarket amp from coming on. One solution is to use a...

That's true... I was assuming (I know, I know an a_ _ out of me and you) that his unit would automatically self protect and shut down if his speakers clipped again. I had a similiar issue with my clarion head unit and the stock MACH audio door speakers... after I changed to the Memphis 5x7, I...

Not quite sure, but a few steps in troubleshooting: -Try fading all fwd and all rear -Try balance all left then right -Try both at same time (ie all sound to right/front) -While doing this adjust volumn through entire range -These steps may isolate a failed speaker (a speaker that has blown...

What you need is a line output converter. They work decent for installing an after market amp to a stock HU. I tried this with my audiobahn amp and stock MACH head unit. The only negative thing I noticed was that with some music, my sub volumn would stay almost level (at time the sub would...

Hey all, I have been part of the forum for some time but never really posted anything on my truck. Well, here is a link to my Car Domain page. Stop by and let me know what you all think. The Toy is still a work in progress... maybe someday I'll catch up with the other Jeff (boosted) or...

I have had teh Dynomax Ultraflow on my 5.0 99 Neer for about 18 months. It has a good sound until around 2000 RPM ( about 60mph in overdrive).... then comes the drone. I have had people tell me it is very loud at WOT. It did give quite a noticable increas in HP also decreased my gas milage...

Common problem I just replaced the rear ABS sensor. Get under your vehicle and look for a cable on the top of your dif. The cable is attached to the rear ABS, remove the single bolt and the disconnect the switch. BTW the switch cost about $23 at the dealer (Motorcraft). The guy at m...