Search results

Ok since I probably could have figured this out, I had been slowly replacing a lot of parts on my ST. Although not hard I had spent more time on it than I had wanted. I did not take it to the dealer but decided since I started to hear the exhaust manifold leak get louder and louder, and noticed...

Hi all I had the typical ABS, TSC, and then wrench light come on. Replaced rt front bearings with sensor and thought that would do the trick since it was making the hub bearing hum noise. Noise is gone, but lights came back on when driving 40mph and 70mph. Bought a code reader told me it was...

HELP!!! I have a 93 Navajo with 160000 miles I went out and tried to start the beast and I would only get a click noise. I have a new battery changed battery post connectors new starter and new solinoid. After disconnecting the battery and replacing the starter and hooking it up it would...

Well Guess what I had the garage look at it finally. It was the intake manifold gasket and the O rings on the injectors were hard as rock so they replaced them. Truck is running like new, after new TPS and air intake valve, pcv, air filter and cleaning of the MAS, that I did. Just wondering...

I replaced the TPS also, scratching head.

I did chceck the mats a couple of times LOL. I have now changed the IAC with factory. It tries to go down to about700 rpm but sounds like it is going to stall then as the vehicle warms up it climbs up to 1100 now. Also when I drive the rpm goes down slowly as my speed decreases, and after...

Just another note after cleaning the I A C it now stalls on first start up and I have to resart it about 2-3 times. It is now running and idleing worse.

I will try all that stuff I appreciate all the info this site has been very informative.

will try tightening the bolts does anybody have the torque specs and which pattern I might need to tighten them in? Also recleaned the IAC and now when I start it , it seems to stall out at first, and with a couple of tries it starts up but the RPMS stay up at 1100 - 1200.

I think I did all except for the vacum leak check. I will try that do I just get some soapy h20 and spray on the hoses. I had the valve head covers replaced last winter and the head gasket 3 yrs ago all the hoses look pretty good though. Will try cleaning the IAC, a little more. Thanks again...

If reseting the computer is disconectiong the battery for awhile thats what I did. It worked for the first time, the rpms went down to 875 then has kicked itself back up.

Okay I have read all posts on this. My Navajo is idling around 1200 rpm. I changed the TPS as suggested by the search that I have done, cleaned tha MAF filaments, changed the PVC and air filter. It now climbs to 2000 on start up and then drops to around 875. Whats the problem? you ask, well...