Search results

Hello! Could someone tell me the part numbers for the 2 Temperature sensors that go into the thermostat housing. I know one goes to the PCM and the other goes to the temp. gauge, Thanks! Chris.

Clicking from Glove Box. Heater/Blend Door prob? Thanks for the quick reply chefduane. You have any idea how tough a job this will be?? Am I going to have to remove everything behind the glove box? Thanks, Chris H. :salute:

Good evening everyone. Had a loud "CLICKING" come from behind the glove box today, from what I believe to be the "Blend Door Actuaror", or the housing of said part. Heater is running at it's highest temperature setting only, even when I lower the temperature setting to it's lowest and turn it...

Calling all Transmission experts on this forum. After much reading on my transmission problem, I need a good diagram/schematic or photo of where the TSS sensor is located on a 1997 5R55E transmission. I'm aware that it's an internal sensor but I'm assuming that it has a plug/connector on the...

ODS Sensor delete I don't think I've had the ODS sensor deleted, but I can't be sure until I get up under the truck. I did find the TSB you referred to, so I'm assuming that the sensor should be deleted if it hasn't already. The article I found read as this: Article No. 97-15-28...

Thanks for the reply. I haven't seen the OD light in years. Depressing the button on the gear shifter to turn it on or off does nothing. Where would that sensor be located, and would it have anything to do with the tranny shift problems & the PO715 error code?

I got a PO715 code showing up. The read out said it was the Transmission Speed Sensor causing the problem. It read:"P0715."Transmission Speed Sensor circuit condition. Vehicle speed above 15 MPH while transmission output shaft speed below 60 RPM. Possible cause Failed transmission speed sensor...

Cleared the PO715 code/changed sensor, but same problem. I cleared the code and drove it for several days. Drove fine at first, then the Tranny once again started doing the same thing and the code came back. I replaced sensor, but same symptoms: Check engine Light came back on. I took it to...

Greetings all. Here's the problem. The other day, my Explorer gave a hard jerk while changing into 2 (maybe 3rd?) gear. Never happened before. I was under 20 MPH & had just stared it. Speedometer works as do all the dials. My Check Engine light came on & when I had the code pulled it read quote...

Problem solved. I replaced the battery, starter, battery cables, and finally the alternator, and now the truck runs perfectly. From what I was told, the alternator failed, which caused the battery to fail, which in turn caused the starter to fail. Having less than perfect battery cables...

Problem solved! FINALLY! Wierd electrical/ignition/starter/problem After replacing the battery, starter, battery cables, and finally the alternator, the truck runs perfectly. From what I was told, the alternator failed, which caused the battery to fail, which in turn caused the starter to...

Alternator bad as well Recharged battery and bench tested starter twice. Starter passed both times. Also had alternator tested while I was at it, and it showed as being bad. Since it was under warrenty, I replaced it. Soon as I get new battery cables, I'll put it all back together, triple check...

Alternator was bad. as well. New starter checked out OK. Bench tested twice to be sure, and battery has been recharged. Curiously, the guy at the parts place thought that the alternator may have been the reason why this whole series of events began, when I tried giving a jump start to a friend...

Wires are now out I went and pulled all the wires from the battery & relay all the way down to the starter. Although they'd seen better days, they wern't all that bad, just a few places on the negative cable were it grounds to the chassis & frame. Of cousse it would be foolish to put the old...

Bench testing starters. A quick question. I'm taking my starter in to be bench tested today. The original one I took off the truck failed a bench test & I replaced it. However, continuing problems are forcing me to go and have the replacement tested as well. My question is simple: A...

Whew!!! Thats a relief!!! You had me worried as hell there for a minute. I'll be pulling the starter and battery today and taking them to be tested and the battery charged. Wire/cable removal, inspection, replacement from all the relative starting components is the next order of the day:salute:

Err..... I'm hoping your'e not refering to the ENTIRE wiring harness. If so I may as well get ready to sell it for parts or scrap it. Of course if its just all the cables and wires connecting the battery, starter, relay, etc. etc. then that was ny next step.

Problem NOT solved. Worse! Got old starter off, new starter connected & mounted. Was able to crank truck and I thought my troubles were over. Unfortunately, the truck wouldnt start a second time. This time the symptoms were a rapid CLICKING sound from fender mounted relay and that was all. Went...

Greetings. Here's the deal. Got new battery, car won't start. Starter is suspected to be the problem. Did all the checks at the connections, cleaned battery terminals, tested fender mounted starter relay, everything was as it should be: Power at proper points at proper times. Removed battery and...

Problem solved.... There was a small tab on the backside of the plug (Yes, it was a plug) Depressed it and off it came! Once again many thanks for all the help and advice I've recieved from this forums members. in my starter project. Thanks to all! Chris

Relay wire "Plugged" into starter. Thanks for the info. It's greatly appreciated. The starter is loose and ready to drop EXCEPT for one thing: The small RED wire attached to the starter & running to the relay on the fender, is "Plugged", for lack of a better term, into the starter. The wire...

Advice on how to remove starter? Starter problems OK, I've checked the power at all the relative connections and I have power where I should at the times I should. There is power at the starter (The big RED wire) and I assume there is power at the small RED wire, but I cant maneuver around to...

I checked the connectiom at the fender relay, & even replaced it with a new one. It's operating as you described it should: Constant power at the lower connection, power at the top when trying to start I got it to crank up once this morning, Cut it off after 20 minutes, then back to "CLICK" &...

:rangerred: Hey Dave1955. I just crawled out from under truck. Can't find any damaged wires, but the top of the starter is in a damn tight place. From where I'm laying, there's no way to see up on top, and Im not familiar with how it connects. Trying to feel by hand isnt a lot of help. Not...

Anti Theft You know, I ran across a thread on this forum that refered to that. I suppose it's not outside the realm of possabilities. Especially since the door lock engage/disengage after every 5 or 6 tries at the ignition switch. I was able to get it started once this morning, but since...