Search results

Have you checked your IAC and MAF?

Or you can try these E Bay

Try this write up Replace cruise switch If you need the stitches they are cheap off of e bay and amazon

I believe the neo-wedge bulbs t4 type b are what I used. look for the non led ones T4 I just checked out the site bulbs are half way down the page.

Do they lock and unlock using the passenger side door switch or rear door switches for the individual doors?

I think you answered your own question Knock sensor question

If you also have fog lights search for a mod to have fogs and brights working at the same time. Just remember this maybe illegal in your state.

Is it a OEM MAF or a calibrated MAF for the air filter?

One way to test is make sure the outer door handle is pushed in and see if it unlocks and locks easier. The spring pulls the handle into the door if its broken then the lock thinks the handle is up and wont work.

CRC MAF Cleaner most autoparts stores carry it

Floor mats maybe?

Just a little heads up. When I replaced the female belt part, after a while the old male part would just pop out. You might want to change out both sections so that you have a matched pair. This might have just been a difference between the two parts, but if your getting the belt from a JY you...

If I remember correctly I really had to work it to the side, took a bit of doing and yes it was stretched across the housing very tight. Does yours have what looks like a wire loom cover on it? When I had my intake off at a latter time, I noticed that the wire goes under the fuel rail.

Might be the knock sensor wire. Mine was going over the thermostat housing when I first changed the housing.

Did the gasket look like this one? This is the one that your 99 SOHC should use.

This is one of them Led Cluster But I do remember another one where LED bulbs and resistors were used, maybe in the lighting section.

Battery maybe? Have you tried jumping it?

Dont get the Dorman replacement it will do the samething. I dont use the rear glass much, so I just have the blade sitting on the edge of the glass. Works great this way.

If your not in a hurry and Rock has the parts in diffrent warehouses, just add them to your cart and check back everyday. Ive done this a few times and the parts at some time end up in the same warehouse.

Cant see how the autolamps fit into the problem with only his not working. Had this same problem on a voyager. replaced mfs and bulbs still did not work.(Funny thing is Haynes and Chiltons did not show a MFS on this model) Got some new light connectors and wired them in, problem solved...

Sounds like the thermostat is stuck open. Has this just started or has it been going on for a while?

6 bulbs 194 Id use 194LL they last longer. Dead Link Removed Stop when the cluster is out you dont have to take it apart the bulbs are in the back. You can get a 96 manual here Dead Link Removed dont know how diffrent the 95 and 96 are.

p0171 p0174 Sounds like a vacuum leak. Check vacuum hoses for cracks. Spray starter fluid around intake while motor is running listening for a change in how the motor is running. Also check the thin black plastic vacuum lines on pass side because of the heater change. also look at the black...

Junkyard for a seat. Should pull out the seat to check it out easy to do just 4 bolts and a couple of wire connectors. Slide seat up take out rear bolts then slide seat back take out front bolts unhook electricals and pull out front door.

+1 ^^^^ Shocks first then bushings and end links 5th shock also