Search results

They will lock but not unlock. I have a remote starter with the lock and unlock feature. Doors lock with the remote but not unlock. Neither the drivers side or passenger side manual switch will unlock the doors, but they will both lock the doors. I pulled back the accordian type cover on the...

Sounds like the inertia switched got tripped. Pull back the carpeting front passenger side. You will see a switch located on the firewall close to the tranny hump. Press that and try starting. Also make sure the wires going into the switch are seated properly. They have a tendancy to work...

Ditto.

I'm assuming this is what the problem is. Yesterday, the seat back gave out and won't lock into position. If I put any pressure on it, I fall straight back into the rear seats! :eek: So for now, I have the driver side rear seat folded down to hold my seat back in place. Works great, but I...

I had a surging/idle problem with my 94 Sport a few years ago. Some of your symptoms sound similar so I thought I'd reply. I did all the stuff like plugs, wires, and checked all vacuum connections. Still had the problem. Turned out to be the PCM. I also had an occasional shuddering when...

For future reference.......... http://mobile.jlaudio.com/products_stealthbox_detail.php?fit_id=1493

There's a method of pulling the codes by using a paper clip and counting the flashes of the CEL. Use the search function to find the process. A few years ago I had a surging problem. Had the vacuum checked and all was good. Turned out to be a bad PCM. PCM controls the idle speed...

Another tire problem is seperated belts. I had a nasty shake at the same speed range. Seperated belts was the culprit. Try swapping the front for rear tires to see if it goes away.

I have a '94 Sport. Power everything except manual cloth seats. Black bumpers, manual factory sunroof and the JBL Premium Sound CD with subwoofer.

Lost my right turn signal yesterday so I bought a new bulb today and replaced it. Still doesn't work. It lights up when I turn on the right turn signal, but no blinkie. Left turn signal works fine. Any ideas?

Have you checked the IAC? Tried cleaning it? Also check for vacuum leaks.

Chances are your pads are low too. The light coming on tells you that the brake fluid reservoir is low due to the pads being thin. It takes more fluid to fill the brake lines since the pads have to travel further because they are due for a change. Get them checked pronto.

I had a leak at the timing chain cover on my 94. The place I took it to drained the system and used vacuum to suck some weld bond into the small area it was leaking. They've done this before and had good success with it. It worked great for me and is still holding up a year later. A whole...

Can this be done on a 94 Explorer Sport? I have the "normal" single switch, either it's on or off. Did any of the Gen I Ex's come with an intermittent rear wiper? Perhaps the Eddie Bauer? If so, anyone swap out the normal switch for an intermittent one? Or is this not do-able?

Ended up being a broken wire to the brake light switch which is located at the brake pedal(go figure! ;) ) Apparently this is a common problem on Fords. Thanks for the input everyone! :thumbsup:

A little cool this morning so I started the truck with the remote starter. Got in and went to Tim Hortons coffee shop. Turned off the ignition..........truck STILL running! Remote starter has a function where if you press the start button while the truck is running, you can take the key out...

See if this helps. http://www.explorerforum.com/Singleton/web/pages/fourwd.html

Check the amount of grease in your hubs. Over-greased hubs can cause all sorts of problems.

Nice ride! Congrats! Did you get them down to $1000?

Born and raised in Leamington, Ontario. Now in Winterpeg, Manitoba.

Gen I's look like a truck, the rest look like vans. :p: Love my '94, it's NEVER let me down whether it's 100 degrees or 40 below. :thumbsup:

Possible intake gasket, IAC or even the PCM.

Check out this thread. http://www.explorerforum.com/forums/showthread.php?t=167932 You many have the same problem as I did.

Turned out to be the liftgate wiper disable switch. Thanks again, you were a big help! :D

Thanks, great stuff! I'll be checking out that disable switch next. Thanks again! :thumbsup: