Search results

Looking on dealing with junker/wrecked vehicles for some supplemental income... thats another story My question is if I can use a two wheel tow dolly or a full auto transport trailer, and tow another vehicle up to 100 miles with my explorer? Its a 1994 5 speed swap, 3.23 gears (note: i do have a...

My apologies for the rather harsh title, I'm tired of trying to fix this to no avail. I've been fighting it for 8 months now. I drive and the drivers side rear brake gets hot as hell, I've warped two brand new drums to the point of being unusable. Its the parking brake dragging... and I have no...

what style wheel cap is designed to go on these wheels? Got them on an explorer without the caps

so I did a M5OD swap on my 94 Swap came from a 91, which coincidentally was a swap as well. I didnt swap any hydraulics out because they were new. I found out afterwards a 91 master does not work with a 94, but i made it work by bending the shaft that goes from the pedal to the master But its...

if there's a better section for this please let me know I have these wheels, I like them alot and I want to use them when I get larger tires, but they're corroded all to hell. Picture is misleading, its pretty bad. Anyone know how to re-finish them?

So a trip to the tire shop for a hole patch turned into a new set of tires :rolleyes: Going with the BFGoodrich K02s in 31x10.50r15 size I plan on either a 2 inch lift, or if they fit the front without rubbing ill just do an AAL in the back to give a little rake for a more aggressive look. My...

1994 Expy So a tremendous amount of dirt in my fuel has wreaked havoc on my injectors... i have another set from a 91 i parted out, but they are black top instead of red. Are these interchangeable? As far as I can tell they're just a different spray pattern, so not mixable. Looking to replace...

Let me start off by stating that the only place I've gotten fuel for months now is the Amoco I pass on my commute. had a misfire + low fuel pressure issue, as well as injectors buggering out replacing injectors as they went out and replaced fuel filter, all was well... for a bit. Then it got...

ABS light came on randomly a few weeks ago, haven't done any brake work in a while. Standard Operating Procedure for the pesky ABS light is to hit a dirt road on the way home and lock up the tires, but this time it didn't work... i just slid to a stop. No biggie, it can wait until I fix the...

Currently stripping a 91 expy to the ground for a part out, got to the core support and aprons and am met with a decision to make. Is it worth my time to drill every spot weld and sell the core support and aprons as used? If so, how much would I be able to get? Are the even reusable when...

anybody have the part # for a 94 explorer manual tranny wiring harness? Thank you in advance.

anybody had any luck? Looking for a 94 manual xploder ecm w/o Calif emissions, anything to watch out for?

I have a strong 91 motor, and an old weak 94. can I strip the 91 down to long block status, switch the 94 components over, and use it? I'm thinking specifically about stuff like the camshaft position sensor...

94 expy, currently getting the pedals in for my M5OD swap, and I needed to drop the parking brake mechanism. In search of a little more slack, I set the brake and put vise grips on the cable underneath at one of the brackets it passes thru, and when I released it I heard a few clicks, and now...

willing to pay shipping to the topeka ks area as well, let me know what ya got

I have a 94 explorer with 275k that needs a motor rebuild, and I want to temporarily slap a 91 motor into it for a couple weeks. Is it at all possible?

I have a 94 explorer auto with 3.27 diffs that just rolled 275k. Body and interior is in nice condition for these trucks. But the motor, shes getting a little tired. Burning oil and being generally weak are the main concerns, and collapsing lifters are on the horizon. The (stock) A4LD is still...

Gonna be getting a lift when I put new rubber on the 94 exploder, which shouldnt be long now as I have 7/32 left on the ole goodyear wrangler radials. Now, I hope to just do a suspension lift, and I'm trying to decide between 2 or 4 inches. I have stock 3.27 gears (yikes, I know), and I plan to...

I'm after a first gen brush guard, I know they're few and far between. I will pay shipping to the Topeka, Kansas area, or I'm willing to drive a couple hours to get it. Let me know what ya got.

The following link goes to rockauto for the rear mains for my exploder, and they dont have a ford seal. Which brand is a suitable replacement? 1994 FORD EXPLORER 4.0L V6 Crankshaft Seal | RockAuto Also, what else should be replaced while I'm there? I'm gonna do the transmission front seal...

As the title states, I have a 94 exploder with an oil leak that only leaks when the truck is parked amd I'm losing about a quart every 1k miles. It's from the bell housing area, and I know it only leaks when parked because the exaust and transmission crossmember is oil free, but the oil is...

I can find a few different brands of remote start kits (without keyless entry, those are double cost) for ~$60 on amazon. My question to you is, is there any threads here on installing these on a first gen? Tried the search function, didnt see a how to, or much useful information. Also, am I...

I have a 94 explorer XLT 4x4. I am getting roughly 13mpg with 90% of my driving being 45-55mph. My DPFE sensor is faulty, getting the code for it and it opens too much with very slight throttle application, even in park, causing very bad stumbling. I currently have the vacuum line pulled off at...

Northeast Kansas- (Willing to ship) Looking for a chrome rear bumper for my 94. Also, a hitch from 1st gen (preferred) or 2nd gen (hear will work with minor modding). Sadly the only pick-n-pull yard near me doesent have anything at all. :( Let me know what ya got!

So my local pull it yard doesent have any first or second gen exploders, so I was wondering if I could just find any old blot on hitch that fits my frame width and use it with some fabrication and drilling? Is there any complications I may run into? I think I know the answer to this one, just...