Search results

2001 4.0 Yep another one, but more directed at oil delivery inquiry. Dealing with dreaded timing chain noise (driver side top, close to the adjuster). Possible oil delivery issue? Full timing chains sets (chains, guides, adjusters, etc) replaced about 1.5 yrs ago. Engine was notably clean when...

2001, 4.0 lacks power on acceleration. Feels like no spark advance. On highway, kicks down a gear, but has little additional power. Speed and rpm will increase, but much slower than normal. Otherwise runs great. Any advice?

Looking for driver door lower hinge assembly. Hard to find, any suggestions? My issue is the rubber ring on the roller is gone.

Can the valve lifter/lash adjusters in a SOHC 2001 4.0 be replaced without removing the cam? I see many posts about the engine with pushrods, but not SOHC.

2001 4.0 Had timing chains replaced - complete set. Now, about three weeks later there is a rattle from the driver side isolated at valve cover above the 2nd spark plug from the front. Used a wooden rod-to-ear to isolate the source area. Rattle is louder at idle and almost non audible with...

I'm thinking of adding subwoofer to my 2001 Explorer XLT (not Sport Trac). Not looking to rattle any windows, just create a more full sound. Since this was built without a subwoofer from factory, looking for any ideas and thoughts of adding the setup ( box location, speaker, amp, wiring...

Having issues with keyless entry with my 2001 Explorer XLT. Replaced key fob and batteries, but still having issues. It did work fine then suddenly stopped. Was able to reprogram new fob, but the system reacted intermittently when the buttons are pushed during programming and general use. One...

Have 2001, 4.0L and working through a transmission leak. Decided to start easy and replace the dipstick o-ring. However, noticed the dipstick tube is actually two pieces. The upper piece is what one would expect, but this fits into a lower tube (about 6-7 inches long) that leads into the...

About a month ago I painted the roof of my 2001 Explorer XLT due to the common/notable paint fade. Now I noticed the rain channels that runs the length of the roof that's about 1-2 inches above the doors on both sides are sticky. All other parts of the roof that was painted is fine (not sticky)...

Can someone help identify and tell me how these are to be connected? The red one has intake vacuum and the white one I "think" is for the heater control flow valve (which I do not have). If I pull vacuum on the white one, I get air distribution selection (defrost, registers, floor, etc). Also...

I am trying to remove the upper oil pan on 2001 XLT with 4.0 V6 2WD. I have removed the lower pan, all of the perimeter bolts, the 8 bolts that go into the mains, the 2 transmission bolts in the rear, and oil pump screen. The upper pan is very stubborn and solidly attached to the block. Tried...