• Register Today It's free! This box and some ads will disappear once registered!

blend door actuator problem

  1. B

    HELP! Big coolant and idle issue

    Hey guys, Blake here. SO here's the new issue with the Exploder. For some apparent reason, I am losing coolant all the time, but it's not usually in the ground, it's on the underside of the engine. I'm talking like a gallon every other day. I just recently installed my 3rd thermostat...
  2. J

    No heat when stationary at idle

    So have 05 explorer 4.0L 4x4 also with rear ac/heat. Problem is no heat when not moving. The core gets HOT. While I was low on coolant, I topped it off and same issue. Lots of heat while driving, but come to a stop and starts to cool off . Seems like outside air is "pushing" through the...
  3. H

    Heat Problem... blend door or heater core or???

    I have a 1998 Ranger clone (Mazda B2500) 2.5L 4 cylinder. The truck currently has no heat. Here is what I have done so far........... Drained and flushed the radiator. Drained and back flushed entire system with Prestone back wash hook up kit. I did not use chemicals though. I broke the...
  4. N

    How many problems do I have?

    Ok, I need some one's experience before I tear into this. I am a pretty common sense mechanical minded dude. Here is the list of what I know. by the way have only had the Eddie Bauer for just over a week.:exp: First all fuses are good. The relay for the air conditioning under the hood is...
  5. M

    LH temperature blend door actuator electrical connector

    Hello everyone, I have a 2004 Ford Explorer 4x4 V6 with manual A/C and climate control. My blend door motor which was recently replaced was not moving when I turn the temperature knob from hot to cold. Long story short I messed with the blend door actuator connector pins and moved them around...
  6. CamDJClimited

    Blend Door or Actuator Probelms??

    Hi all, I have a 96 Ford Explorer Limited V6 with the Auto Temperature Control. It acts strange. Even with the Temperature Control off, I still hear a clicking or tapping noise coming from the Blend Door or Actuator. I put my finger on the top of the Actuator and I could feel some little piece...