code

Hi All, With the winter being here, my car got nicked by some gravel thrown up by the snow plow. Minor in size but deep. So wanted to use a touchup pen. I looked at the inside of my door where the VIN is listed and saw the EXT PNT Code: HS. The samples look a little off from what I would...

Howdy! I have a 2000 Ford Explorer Sport. Currently, it has a check engine light for P0171 and P0174, stating that it's running lean. I used a smoke tester and found a substantial leak-- one of the hoses is ripped apart. While running, moving the hose causes the idle to fluctuate, and a lot of...

I searched but didn't find anything helpful. 2000 Explore XLT 4-Door 2WD 4.0L SOHC 130,000 Miles. The ABS light on the dashboard is ON. I just finished replacing the front left and right UCAs. While doing this, I removed the ABS sensors from the steering knuckles. One sensor's face was...

Hi, I have been trying to get my entry keypad to work without any luck. It's completely dead no lights nothing. I've replaced the keypad and still nothing. i check the voltage in the connector and i'm getting about 12v from the first two pin holes, the second two pin holes have about 7.5v and...

The car: 2005 2WD 4.0 automatic with about 110K miles on it. The symptoms: Check Engine light comes back on within 20-40 miles of being reset P0193 code (fuel pressure sensor high) Poor gas millage, around 12 MPG (was about 18 MPG a year ago) Occasionally runs slightly rough, mainly at idle We...

hi my name is mark i have been FORD for as long as i can remember. i have also built a few HD bikes that said i would rather be riding mine as to doing this.eney ways back to greasy fingers. CALIFORNIA GRINDIN! curently working on my daughters 96 explorer got a p0125 insufficient Coolant...

I have a 2012 Ford Explorer and I don't know the factory door code. Does anyone know where it is located on the 2012? I know I can go to the dealer and they can get it but not without a price. Any help would be greatly appreciated...

Hi, I want to give a solution I found for the error P0351: SYMPTOMS: I had no spark from the coil to the spark plug in the cylinders #1 and #5. PLEASE VERIFY THE NUMBER OF THE CYLINDERS. With the engine running check for the spark. The coil connector has 4 yellow wires. For the cylinder 1...

anyone ever put one of these guys in ? wires :eek: is this something i can do or leave it to the local guys (180) ?

Service Engine? What do these codes mean? - FIXED! My Service Engine Light just came on out of nowhere. Ran a scanner and I've got two codes... C1342 - General Module / Timing Control Module Defective P0174 - Bank 2 System too Lean 2003 Explorer Eddie Bauer 4WD What is going on? I...

What are my options for resetting the codes? i got a code 52..which happened when i was doing some electrical troubleshooting and had KOEO with one of the harnesses disconnected. So far i heard the dealership will do it for a large fee... I can cycle the ignition 250something times and it...

Hey all, IN SHORT: What does this mean? abs code: C1102 "Acceleration Switch Malfunction" How do you fix it? What is the Acceleration Switch? IN LONG FORM: I've done some searching, but i can't find anyone with ONLY this problem, and I'd like to work towards a simple solution hopefully...

Code number diagnostic chart for use with E-4WD equipped Aerostar vans.

My son recently bought a 1996 Explorer sans smog cert. Yes, I know. I've already given him the forehead slap but we must move on and now we're trying to get it to pass smog so we can complete the title transfer. His mech (they're in a different city from me) said it showed a PO761 code. Based...

i have a 92 explorer 4.0 4x4 and im having problems with it, i would like to know how to pull a code and where is the best place to look up the code so i can figuer out whats going on with the truck...

Hi Hello every one, :) I have a 99 Explorer E.B. 4x4, I'd change my automatic trans from a junk a few months ago, I get a 2002 Explorer Sport Trac Trans, a week ago I passed it a few times in the water (not in the sea) a few days ago a DTC appears, first "check engine" and later the "O/D"...

ok here's my issue, in the course of tuneing up and working on the engine, i've broken many vaccume lines, so many that i dont know where everything is anymore, i do know that they would go to the vacuum tree, anyways the only thing's i have hooked up to the tree are the break and cruise, and...