end | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

end

  1. M

    Intermittent click noise from from end - with video

    Hey folks, Hoping to use some collective experience and brainpower to diagnose an issue. I've done extensive searching about clicks and rattles coming from the front end, but nothing that quite describes this. Nothing seems broken, it's just driving me insane. But I finally got it audible on...
  2. A

    Creak/pop noise from front end

    I've been going crazy trying to figure out what is causing this insane popping/Creaking noise front my front drivers side. I've recently noticed it only happens when I'm turning my steering wheel right, even if it's just slightly. Even yesterday I just parked and rocked the car side to side and...
  3. D

    Sway Bar End Link Fun!

    Driving along today, I heard a loud pop. And when I say loud pop I mean, I thought someone fired a gun under the truck. I knew it came from the front passenger side and pulled over right away to find this.. The end link literally just got shredded at the top. Of course this had to happen...
  4. K

    92 explorer sound

    I recently bought a 92 explorer sport off a buddy for $200 but it had a few problems such as it needed rotors, a seal for the rear end and new brake lines from the splitter to the wheel cylinders. That is all done but there is a strange sound coming from the left front wheel. The best way I can...
  5. M

    annoing noise! please read!

    Hi, I have a 94 explorer and just recently I have been getting a real load noise coming from the front end. It almost sounds like the growl of big beefy tires on the road but I have regular tires on it. When I drive strait you can hear it and when I turn left it gets even louder but if I turn...
  6. Slap hammer with the previously stuck end plug.

    Slap hammer with the previously stuck end plug.

    The part on the end of the slap hammer is an end plug which was originally stuck in an A4LD valve body.
  7. A4LD valve body with a slap hammer removing the stuck end plug.

    A4LD valve body with a slap hammer removing the stuck end plug.

  8. A4LD valve body with a screw in the stuck end plug.

    A4LD valve body with a screw in the stuck end plug.

  9. A4LD valve body with a brake adjusting tool behind the stuck end plug.

    A4LD valve body with a brake adjusting tool behind the stuck end plug.

    I put this tool in this place to prevent the drill bit from going too far into the bore when the drill bit goes through the end plug.
  10. A4LD valve body getting the stuck end plug drilled.

    A4LD valve body getting the stuck end plug drilled.

  11. A4LD valve body end plug with a hole drilled into it for a slap hammer.

    A4LD valve body end plug with a hole drilled into it for a slap hammer.

    This is the end plug from an A4LD which was stuck in the bore. I had to drill a hole in it to attach a slap hammer.
  12. Truck pics

    Truck pics

    New rear diff cover.
  13. Yoke to axle

    Yoke to axle

  14. New 3.73LS w/ SVO cover

    New 3.73LS w/ SVO cover

    I just finished puting in a brand new 3.73 LS rear end to replace my 3.27. I also put the SVO axle girdle and Roadmaster Active Suspension system that really calms the back down.
  15. coils

    coils

    this is the front end w/o bumber , this is after the 133 coils and new front reciever.
Back
Top