hole | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

hole

  1. Eric Z

    Explorer PIU Overhead Cut Out Question

    I have a 2015 and am looking for ideas as to what to do with a hole left in the overhead. I assume it was some sort of radio or maybe light control panel, but what was in there and what are people doing when they civilize theirs? Was thinking of overhead lights, but can not seem to find any...
  2. S

    Shackle Bolt Hole

    I am in the process of making my own extended shackles and I need to know the stock bolt hole diameter. I really dont want to take the stock one off just to check that. If anyone knows it that would be great.
  3. The spring has to go into the hole in the bracket.

    The spring has to go into the hole in the bracket.

    This is a sliding door latch modification to prevent it from jamming.
  4. Drill a hole then pry it out.

    Drill a hole then pry it out.

  5. K

    tranny/engine leaking/hole...

    :rangergreen:I am a proud owner of a 91 exploder with a manual tranny and the 4.0 v6, nicknamed thumper, due to the bad lifter and my stereo system. I absolutely love it. Anyway, now to the pont, my engine started leaking oil, right at the bell housing? I know my way around the top part but not...
  6. N

    large split in the muffler and backfiring.

    so i finally got my truck up and running, but on the test drive there was a loud back fire, driving back home it kept back firing, several times idling at lights and about 5-8 back fires upon accel before i reach 25 mph. i also noticed a huge power loss. checked under the car and theres a large...
  7. Mark the upper hole.

    Mark the upper hole.

  8. Drill a quarter inch hole.

    Drill a quarter inch hole.

  9. Double check the alignment of the hole.

    Double check the alignment of the hole.

    Don't drill a 1/4" hole until you check the alignment first.
  10. Enlarging the recess hole.

    Enlarging the recess hole.

  11. A hole is made for the locking pin.

    A hole is made for the locking pin.

  12. Adding differential fluid into the sensor hole.

    Adding differential fluid into the sensor hole.

  13. Punching a hole in a gasket.

    Punching a hole in a gasket.

  14. A hammer punching a hole in a gasket.

    A hammer punching a hole in a gasket.

  15. The 1 1/2" hole is in the sink.

    The 1 1/2" hole is in the sink.

  16. Drilling a 1 1/2" hole.

    Drilling a 1 1/2" hole.

  17. A4LD valve body end plug with a hole drilled into it for a slap hammer.

    A4LD valve body end plug with a hole drilled into it for a slap hammer.

    This is the end plug from an A4LD which was stuck in the bore. I had to drill a hole in it to attach a slap hammer.
  18. Clean this hole before soldering.

    Clean this hole before soldering.

  19. Firewall port

    Firewall port

    Show the location of the firewall port for temperature lines.
  20. Hole

    Hole

    hole
Back
Top