Hey, I have recently bought a ford ranger with a supposed low mileage tranny swap.. it bust on us, so got a new tranny, replaced the clutch, slave cylinder, throw out bearing etc.. putting the tranny in.. got it all in place, 5 of the 6 tranny-engine bolts in place, except the very top passenger...
Just got this ride and put a new rotor, caliper and pads on my drivers side today. Something's definitely wrong… My ABS light came on and the pedal pushes back at my foot from time to time.. Any advise? Not really a mechanic but I'm definitely Handy.
I recently dropped my transmission to replace the clutch. I am usually very good about labeling my bolts, but idiot me piled all the tranny bolts (one-at-a-time) on the table. I then noticed, a day later, that there are 5 shorter bolts (appx. 2.75 inches in length) and 3 longer bolts (appx. 3.25...
I have a 97 mazda b4000 and replacing the tranny from an explorer. It all fits except the mazda tranny has 2 sensors on the top with 2 leads each. I can use you help in identifying what they are for . Here are some numbers that may help
Original tranny p97GT-7006BBR
Replacement tranny is...
I have a 93 Mazda Navajo 2WD I bought a few years ago and have been fixing it up. I bought a used transmission for it and 3rd+5th grind while in gear and is has no 4th at all. Can anyone give me an idea of whats going on with it?
I setup a portal page for the Mazda Navajo. Just a simple page designed to redirect Navajo owners to this forum. www.mazdanavajoforum.com
I would like to add more photos and more info on the main page. Please submit what you have here.