neutral safety switch

Ok so I have no revers lights in my Bronco II - A4LD trans and 4x4. I first replaced the NSS thnking that was the issue - still no lights. Also its starting in all gear positions now. Will get to that later.... As far as the light issue goes - I Tested Purple/Orange wire in harness and have...

Hello i am new to this Forum and looking for advice from y'all gurus. I bought a complete 2000 explorer 4.0 sohc eddie baure eddition 2wd. -I will be doing a complete motor, trans, PCM and harness swap from this explorer to a 93 Ranger and looking to get away with not using the steering...

My sister drove her car to work parked it and turned it off, hours later after work she got back into her car went to start it up, the lights worked, the radio works, the engine didn't turn over, replaced the starter and starter solenoid (both 1 piece) with new parts, still didn't turn over...

Hello all, 2008 Explorer with 4.0 and 130,000 miles. Vehicle does not want to start in park. I replaced the Neutral safety switch on the side of the tranmission and that did not seem to make a difference. Sometimes it starts sometimes it does not. I can get it to start by moving the console...

I got a trouble code 67 o for my 1991 ford explorer, i want to fix it but i dont know where to start. My transmission is a 5 speed. And i have looked at it under but i cant tell which of the cables is the neutral safety switch. And ive also seen the spring casing thats attached to my clutch...

I have a 1997 Explorer RWD with automatic transmission. Recently I drove off from a stop light and once I reached 30 MPH I heard a faint "CLICK" after which the transmission disengaged and will not shift into any gear. It has plenty of fluid, and offered no warning at all before failing...