to | Ford Explorer - Ford Ranger Forums - Serious Explorations

  • Register Today It's free! This box and some ads will disappear once registered!

to

  1. The foam insulation has to be cut.

    The foam insulation has to be cut.

  2. Use the template to cut the light.

    Use the template to cut the light.

  3. The spring has to go into the hole in the bracket.

    The spring has to go into the hole in the bracket.

    This is a sliding door latch modification to prevent it from jamming.
  4. Use tile spacers to properly align the tiles.

    Use tile spacers to properly align the tiles.

  5. A square is used to align the tiles.

    A square is used to align the tiles.

  6. Two female plugs are used to avoid splicing wiring.

    Two female plugs are used to avoid splicing wiring.

  7. One bolt connects the brake line to the caliper.

    One bolt connects the brake line to the caliper.

  8. Adjust the router to match the depth gauge.

    Adjust the router to match the depth gauge.

  9. The base is connected to the power supply.

    The base is connected to the power supply.

    Power supply with the modified battery charging base.
  10. Insert the tool, and pull on the pipe to disconnect.

    Insert the tool, and pull on the pipe to disconnect.

  11. Always lubricate the O rings prior to installation.

    Always lubricate the O rings prior to installation.

  12. The timer is mounted to the extension box.

    The timer is mounted to the extension box.

  13. Try to disconnect a link like this first.

    Try to disconnect a link like this first.

  14. Hold these two points to disconnect.

    Hold these two points to disconnect.

  15. The face plate attaches to the computer board.

    The face plate attaches to the computer board.

  16. The pressure goes up to a certain point when it's off, then it stops increa

    The pressure goes up to a certain point when it's off, then it stops increa

  17. A low freon charge will cause ice to build up on the line coming from the e

    A low freon charge will cause ice to build up on the line coming from the e

  18. Remove the hood bulb to avoid draining the 9 volt battery.

    Remove the hood bulb to avoid draining the 9 volt battery.

  19. The proper amount of pressure for the system to work.

    The proper amount of pressure for the system to work.

  20. Oil is added to the compressor.

    Oil is added to the compressor.

  21. The motor is installed, and the saw is ready to be closed up.

    The motor is installed, and the saw is ready to be closed up.

  22. The rear shafts need to be cut to the width of the door.

    The rear shafts need to be cut to the width of the door.

  23. Air hose connected to a brass tee.

    Air hose connected to a brass tee.

  24. The screws are getting mounted to the rim.

    The screws are getting mounted to the rim.

  25. Apply a bead of silicone to the base.

    Apply a bead of silicone to the base.

Top