transmission rebuild

I've posted in here several times with this same issue but I figure it was worth one more shot. At 80k miles I started experiencing hard clunking shifts, shuddering during shifts and an occasional flare from second to third gear. I took it to the Ford dealer and had them flush the tranny. Was...

So as I feared I had my transmission looked at and was told it needed replaced. I've used rockauto a ton in the past and was recommended that that's the best route for a new transmission also from someone on here. I have a 2004 XLS sport 4.0 4WD Vin w/K. Can someone tell me which exact one I...

Ok, a little back story: 3 years ago i had the transmission replaced on my explorer due to a hopping or skipping in acceleration, and that cost me more than both arms and a leg at $4500.00. It didnt fix the problem with the skipping and the transmission came back making a whining noise from...

Hi, My 02 explorer's automatic transmission is another victim of the overdrive servo-bore issues; in fact the casing actually broke where the clip holds the servo and its guts poured out. I've now removed the old transmission, ordered a used casing (with servo bore bushings installed) and a...

Hey ya'll, I have a 95 Explorer XLT and just last night my tranny seemed like it wasn't going into 3rd and the O/D light was all of the sudden flashing so I took it to my tranny guy today and had the codes read. I don't remember the code exactly but it was for a 3rd gear ratio error. Is does...

OK - Hey everyone- i'm new here and I need your help! First of all, this is a great site and the contributions here are fantastic!!! So here's the deal -I've rebuilt my 4r70w (with alot of insight I've gathered from here) and all has gone very well. The tranny is back in and I was able...

I am rebuilding the 4R55E transmission for my 98 Explorer 4WD 4.0L. I bought a rebuild kit for it. My original Coast Clutch Internal Plate had a notch on it showing where the "Top" was. The Coast Clutch Internal Plate that is in the kit doesn't have that notch. I'm needing to know if it makes a...

Transmission in 1998 Explorer 4X4 went out. I bought another from salvage yard. When I dropped the pan I found this: Transmission shop looked at it & said it was a bearing. I still have the original transmission. How do I remove the part from it and put it into new transmission?

Hello, I just had the transmission rebuilt and the torque converter replaced on my 02 V8 Explorer 120K. A couple days after, I started getting ATF fluid dripping from the transfer case. Looked it up in my Haynes and it suggested checking the level of the transfer case fluid. When I...