1350 linkage for 1354?

[inh]

I've seen that there is one type of 1350 linkage that will work with a 1354. My question is will ALL of the 1350 linkage work? As long as that one arm is straight like the 1354 is? Or will i have to fab up the rest?

 

[jrgaylor]

Is this thread you saw you info in
http://www.explorerforum.com/forums/showthread.php?t=85170&highlight=1354+linkage
The diffrence between the diffrent types of shifters is the short lever coming off the transfer case and the long lever that it goes to. the rest of the stuff is the same.

 

[inh]

No but it was similar. I actually went to your gallery for the pics. So i assume that everythign is the same, i just gotta look for a 1350 wiht the straigt arm and i can use all of the linkage? Also, Can i install the linkage with the transfer case installed?

 

[jrgaylor]

it can be alittle tight but it is do able

 

[Bronco638]

Also, Can i install the linkage with the transfer case installed?

I did it that way since I needed to fab the short lever (with the pin) coming off the t-case. Actually, I drove around for a couple of weeks with no linkage at all. There's actually quite a bit of room and you should have no problems getting all the bits & pieces up in there and installed.

 

[410Fortune]

1350 and 1354 transfer cases are IDENTICAL, Except for the front output yoke for the driveshaft, only difference.