iskrupansky
New Member
- Joined
- April 4, 2015
- Messages
- 1
- Reaction score
- 0
- City, State
- ohio
- Year, Model & Trim Level
- 1994 ranger supercab
Hello to all,
I have a 1994 ranger supercab with 4.0 v6 we bought at auction in 2013. when i first got it it ran good then it started to stall out then trans puked out. had trans rebuilt in aug 2014. i have this miss/hesitation when i hit the gas from idling like at a stop light ect . had trans back here in march 2015 it wouldnt make speed. thrust washer let lose and screwed up clutch pack. shop rebuilt again totally. they dropped exhast this time to take out and when i went to pick up it wouldnt get any acceleration when it was cold it was cool and rainy. it ran super rough but shifted fine, today i fired up it accelerates better but still a hesitation/ miss when i rev up to about 2000rpm. where the egr is supposed to be it isnt there at all no tubes ect. would the distributorless ignition module be going bad or not firing hot enough? put new platinum plugs n wires in april 2014 new throttle position sensor 2013
I have a 1994 ranger supercab with 4.0 v6 we bought at auction in 2013. when i first got it it ran good then it started to stall out then trans puked out. had trans rebuilt in aug 2014. i have this miss/hesitation when i hit the gas from idling like at a stop light ect . had trans back here in march 2015 it wouldnt make speed. thrust washer let lose and screwed up clutch pack. shop rebuilt again totally. they dropped exhast this time to take out and when i went to pick up it wouldnt get any acceleration when it was cold it was cool and rainy. it ran super rough but shifted fine, today i fired up it accelerates better but still a hesitation/ miss when i rev up to about 2000rpm. where the egr is supposed to be it isnt there at all no tubes ect. would the distributorless ignition module be going bad or not firing hot enough? put new platinum plugs n wires in april 2014 new throttle position sensor 2013
