SonicBlue302
Member
- Joined
- June 10, 2014
- Messages
- 16
- Reaction score
- 0
- City, State
- Miami, FL
- Year, Model & Trim Level
- 2001 Ford Ranger XLT 4.0L
Hello, I have an issue with the housing thermostat, the first one (original ) it has a huge leak so I replaced, but over of a year the new starting with a small leak and big leak, so I decide to buy a new one from different vendor but now started the leak again! so now I don't know where can I buy it from or where should I buy.... any body can help me.
Thanks in advance.
Where is it leaking from? I ordered an aftermarket replacement housing for mine about 2 months ago on ebay n its worked fine for me with no leaks. I recommend you use #2 Permatex non-hardening sealant on the o-rings n seals and that should help it seal better and prevent any leaks. Make sure the surface/block of the engine is clean when you reinstall the part and I would use a little bit of sealant on there as well. You can use a Scotchbrite pad or sandpaper to clean the surface. Hope this helps