Ball Joints

[colindo94]

so i went to the alignment shop today and they tell me i need to replace the upper ball joints in order to get the alignment because they have play. I decided to just do the upper and lower while I was in there. So are there any special tips i need to know before starting the project? I bought McQuay-Norris ball joints. How are they? And I was planning on doing radius arms soon so would it be easier to do them while im already down there or can I wait to save some money and do the ball joints first, get the alignment, and then do the arms later and not mess up the alignment. Well thanks for reading.

 

[cculter]

Rent the ball joint tool (assuming you already did). Put the balljoints in the freezer a couple of hours before you start and they will go in easier. Good luck!