Darkhorse73
New Member
- Joined
- October 3, 2015
- Messages
- 1
- Reaction score
- 0
- City, State
- Western Kentucky
- Year, Model & Trim Level
- 2006 Ford Explorer XLT
Hi! New to the forum, so dont be too rough on me. I recently purchased a 2006 Ford Explorer XLT (my 2nd explorer). As I was driving down the road this week, every light on the dash came on and it shut off. I coasted over to the side of the road and tried to restart the engine. It took about 4 tries but it finally started up. The check engine light stayed on though. I checked the engine codes and I got the following:
P2104 - Throttle actuetor control system- forced idle
P061B - Internal control module torque calculation
P2135 - Electronic throttle control (ETC) position sensor
P2112 - Throttle actuator control system - stuck closed
P2111 - Throttle actuator control system - stuck open
It happened a second time today as I was driving it. I asked a couple of my friends and got totally different answers. I am not even sure where to start? Does anyone have some knowledge they could bless me with?
P2104 - Throttle actuetor control system- forced idle
P061B - Internal control module torque calculation
P2135 - Electronic throttle control (ETC) position sensor
P2112 - Throttle actuator control system - stuck closed
P2111 - Throttle actuator control system - stuck open
It happened a second time today as I was driving it. I asked a couple of my friends and got totally different answers. I am not even sure where to start? Does anyone have some knowledge they could bless me with?