I just got a 53 code Throttle position sensor over maximum voltage.
173 Oxygen sensor is or was not switching,Fuel control
212 Ignition TACH signal was erratic (module/wiring) or SPOUT circuit fault - Ignition Systems
Is it possible that my TPS give me all those codes and replacing it will solve false reading of other units or is it something else?
I am not sure of everything because my 53 code it make 1-1-1 and then make the rapid 5 code and then 1-1-1 and then the rapid 3 code. It reapeat it ...wait ...one flash to tell we go in CM code and begin CM code ...but why on koeo codes it give 1-1-1 as engine passed but just after that it give a 53 code ????
173 Oxygen sensor is or was not switching,Fuel control
212 Ignition TACH signal was erratic (module/wiring) or SPOUT circuit fault - Ignition Systems
Is it possible that my TPS give me all those codes and replacing it will solve false reading of other units or is it something else?
I am not sure of everything because my 53 code it make 1-1-1 and then make the rapid 5 code and then 1-1-1 and then the rapid 3 code. It reapeat it ...wait ...one flash to tell we go in CM code and begin CM code ...but why on koeo codes it give 1-1-1 as engine passed but just after that it give a 53 code ????