dana 44 help

done the dana 44 swap on my bronco 2 just need to know if u can adjust the camber on a solid axle dana 44 hp or not, or is it just castor,toe in, toe out
any help would be great.

 

[IZwack]

Typically, if the camber is off, then there's a bent component, or the inner knuckle wasn't aligned properly before welding.

But none the less, there are eccentric upper ball joint sleeves:

 

[cole01]

thanks for the help i guess its going to the shop to be alined

 

[IZwack]

Well Im not sure the shop can't do anything about camber unless they install those eccentric upper ball joint sleeves.

 

[james t]

Make sure the toe and caster are set right before you think about the camber. Sometimes a bad toe/caster setting will make a solid axle appear to have bad camber when it really doesnt.

Other than that, about all you can do with it is the offset balljoint sleeves as mentioned above.