Deminsions on Roadbully Lift Kit

[Mr.Burns]

Can anyone who has bought/used the Roadbully Lift Kit get me the deminsions on the spacers?

I am interested in making my own. (3" front / 1.75" rear) And was curious if someone here would be willing to blue print them for me..??

Thanks for any help

http://www.explorerforum.com/forums/attachment.php?attachmentid=50982&stc=1&d=1223320682

 

[Kazer]

Don't make anything over 2.5"...

 

[Mr.Burns]

Thanks for the advise. Can you get me the "deminsions" for actual spacers?

 

[HiImBrian]

Thanks for the advise. Can you get me the "deminsions" for actual spacers?

Rather than make your own just pick up a set from Brandon @ BTF fab. here on the forum. To me, for $250 shipped it's worth skipping the headache making your own. Plus it supports the forum and its vendors.

 

[KPPCExplorer]

The reason you should not make spacers over 2.5 inches is because it will wear out your suspension components much faster, especially your ball joints. I have seen pictures where the ball joints have ripped out of the control arm from 3 inch spacers. Also, I believe there were issues with the cv axle angle.

If you want to be that much higher, do the 2.5 spacer with a 1.5 body lift

 

[streetessencems]

PM me your email address...