JackeDRangeR302
New Member
- Joined
- May 22, 2011
- Messages
- 1
- Reaction score
- 0
hey guys, i am new to the forum. a little back ground on me, i am currently an electrician in the navy in jacksonville florida. hope to go back home to washington in a few years though. hoping to get a lot of good tech tips and advice here. first question; i have heard about using fullsize dana 44 axle shafts in early bronco dana 44s. i am trying to find out how much the long side axleshaft needs to be cut down and am i going to have to use the spindle from the fullsize 44. i am hoping to figure this out so i can use larger u-joints.
