I am thinking about going with the Wristed Axle Housing (WAH) setup. But since I have to cut the axle for the installation should I keep it full width or should I shorten them to an EB width?
I know that it basically comes down to personal preference but I was wondering if others did this or would recommend this? How would the flex change if at all? Would I have to cut the fenders if I keep them full width or shorten them? Any other type of extra fabrication will be needed?
If shortened I would also have to cut the ford 9 inch to width. Is it ok to do this or would it weaken the rear axle?
Any info on integrating the WAH on a Full Width axle is appreciated!!
I know that it basically comes down to personal preference but I was wondering if others did this or would recommend this? How would the flex change if at all? Would I have to cut the fenders if I keep them full width or shorten them? Any other type of extra fabrication will be needed?
If shortened I would also have to cut the ford 9 inch to width. Is it ok to do this or would it weaken the rear axle?
Any info on integrating the WAH on a Full Width axle is appreciated!!