Does anyone know where the stock fog lamp relay is located? I want to put power to it when the parking lamps are on, not just the low beams. I realy don't want to wire up a new one so if anyone knows where this is it would be greatly appriciated!
Did this mod today. Took about 40 minutes to do this five minute mod. Located the blu/grn wire and decided to check it first. Cut on the headlights and checked for power then cut off the fogs, checked the power, and the wire was still hot. Dumb a$$ me, not realizing the wire will stay hot so long as the headlights were on. Wasted 30 minutes checking and re-checking. DUH! That's what this mod is about, to bring power from another source. Got to remember what KISS stands for.
’97 Fog Light Mod #3
I did the Fog Light Mod on my ’97 today, but I didn’t use Mod #1 or #2. As we all know, the stock arrangement provides a “hot” fog lamp relay only when the dash light switch is set to “headlamps” AND the column multifunction switch is set to “low beam.” The object of this mod is to provide a “hot” fog lamp relay under other settings. Mod #1 taps into the parking lamp circuit and will work whenever the parking lamp circuit is “hot.” Mod # 2 taps into the radio circuit and will work whenever the ignition switch is set to “Acc” or “Run”. But Mod #2requires running a wire between the fog lamp relay and the radio.
There is a closer solution. The box holding the fog lamp relay also holds the windshield washer pump relay. The windshield washer pump relay is “hot” when the ignition key is in the “Acc” or “Run” and the circuit is fused at 10 amps. It is fed by the White with Black ribbon wire. I used the following components:
- (1) quick splice
- (2) male bullet connectors
- (2) female bullet connectors
- 4” of 16 ga. wire
I took the air cleaner and housing out. I took the relay box off and removed the top and bottom covers to aid in tracing the correct wires. On my ’97, the only two wires of concern are:
- Dark Blue with Light Green ribbon (this feeds the fog lamp relay)
- White with Black ribbon (this feeds the windshield washer pump relay.
I simply tapped into the “White/Black” feed to the windshield washer pump relay with a 4” length of wire using a ‘Quick Splice”. I crimped a male bullet connector onto the free end of the spliced wire. I cut the Dark Blue/Light Green feed. On the end going INTO the relay, I installed a female bullet connector and plugged the spliced wire in. Viola! The fogs work whenever the ignition switch is set to “Acc” or “Run.” I finally crimped a male bullet connector onto the end of the Dark Blue/Light Green wire coming out of the wiring harness and joined it to a female connector to provide insulation. (If for some reason I need to return to stock condition, I can unplug the spliced wire and re-plug the Dark Blue/Light Green wire.)
Here is a pic of what I of the mod.