Now you need to remove the kick panels and column interior pieces. Mine where already missing so I don't have any Pics, but its pretty simple. The kick panel has one screw half way up the door and a clip on the inside by your feet. You will also have to remove the screw holding the bottom door sill piece in.
For the Column pieces you will have to remove the screw holding on the coat hanger peg. Then if you have a 93-94 just pull it off of the clips. If its a 91-92 there are 2 screws you have to take out.
After those are out of the way there are 2 bolts holding on the bottom of the Dash, one on each side near the door.
Now you can remove the 4 bolts across the top of the dash, this is one of them.
Then there is one more above the steering column. Too tight to get a pic but in this pic you can see its threads coming out the other side.
View attachment 212542
When all of those are removed the dash should come off a little, but there are some wires holding it in place. Pop your hood, you need to disconnect the harness. To do this you need to use a 10 MM socket to loosen the bolt that I have circled in the picture. Keep on loosening it until you can remove the plug from the firewall. The arrow points to the Cruise control wires, you need to unplug them from the cruise control unit and push the rubber grommet through the firewall.
Now, once the plug is off there are three clips that you need to push in as you push the plug through the firewall. Once that is done you can pull the dash out a little more. But there are still wires you need to unplug.
I will now show you all of the wires you need to disconnect.
This one is on the top of the steering column. The arrow points to a clip that you need to pry outward to pull the plug up and off of the column. There is another clip just like it on the back of the plug.
View attachment 212543
This one is on the side of the master cylinder, so if yours is an automatic this plug will just be capped off and hanging. use a small screw driver to pry out the clips as you pull the plug off.
View attachment 212544
This plug is for the 4X4 push button. It is behind the dash in the middle of the 2 doors. Push on the clip and pull at the same time.
View attachment 212545
These plugs are for the speakers. The one with the arrow you need to pry up as you pull, the other plug has a clip on the back that you push as you pull.
View attachment 212546
These are the cables for the AC/Heater controls. Pull up on the cable so is snaps out of the silver clip then turn it and lift up on the end of the cable.
View attachment 212547
This is the antenna cable, simply pull it.
View attachment 212548
All of these are located near the passenger kick panel where the ECU is. Picture is self explanatory and arrows point to clips that need to be pried up as you pull. The vacuum hose (A) simply pulls off of (B).
View attachment 212549
This pic was taken after the dash was all the way out but these are two other plugs that need to be disconnected
View attachment 212550
Then where its too tight to take a pic there is a plug attached to the top of the brake pedal and one connected to the parking brake assembly.
Now you should be able to remove the dash entirely and take it out of the truck.
feel free to give your input and remind me of anything I forgot.
Also don't hesitate to ask any questions.
If you screw up your vehicle its your own darn fault