i need help!!!!!!!!!!! well kind

[macknos94]

i got assigned to a welding hemtt so i have all the welding stuff at my hands. i need the measurements for rear of front wheel well and front of rear wheel well. also a measurement from the frame to the pinch welds or right under the door. also a measurment from the top of the frame to the bottom of the frame. once i get them made im shipping them back in the conex so hopefully i can make a set or 2 when im over there just wish i had my truck with me to do some test fitting. if i get to it ill be playing with making a front bumper which ill need measurements for also.

also these are the styles im gonna try to go off of.

http://cgi.ebay.com/ebaymotors/Toyo...ewItemQQptZMotors_Car_Truck_Parts_Accessories

http://cgi.ebay.com/ebaymotors/Jeep....c0.m245&_trkparms=72:543|65:12|39:1|240:1318

http://cgi.ebay.com/ebaymotors/Land....c0.m245&_trkparms=72:543|65:12|39:1|240:1309

 

[97awdx]

Wheel well to wheel well is 78.5"

Frame to door (see pic)

Frame hight is 6"

Have you been deployed yet?

 

[macknos94]

im in fort sill Ok. right now but im heading over end of march. looks like ill be outside the wire more then not so it should fly by hopefully.
thanks for the measurments im gonna start drawing a blue print on my laptop and get to making them

im also gonna make a cover for the brake lines so if i get t boned again my brake lines wont get cut haha. just a simple A tube down the side of the frame

 

[97awdx]