pkn
Well-Known Member
- Joined
- May 16, 2011
- Messages
- 147
- Reaction score
- 4
- City, State
- Houston, TX
- Year, Model & Trim Level
- '92 '05 '10 2WDstockXLTs
Guess what I went and did!
Stuffed a 10" pusher in front of the condenser to assist with better a/c performance at low speeds.
Taking advantage of the fan controls and relays from the previous failed engine cooling e-fan,, ,,e-junk.
Install took 1 hour. Nice!
Gained a 10 degree drop when sitting at traffic lights. Also Nice! Ice... ..
Stupid thing is loud though! But I like 56 degree air when it's 105 out-side.
Great! That's a setup I'm planning now, too: keep main cooling fan mechanical, but add a pusher to keep A/C alive when idleing.
Could you please tell the make/model/CFM/thickness of the fan?
I'm looking at Spal 30100401 (~$75 amazon) 16" Straight Blade Pusher - that's the thinnest (63 mm only!) 16-inch pusher I could find... but if you used 10-inch fan with good results, maybe I'm overkilling it a bit?
I do, in general, like overkills, but I'm not sure the 16"-inch fill fit in front of condenser - I also have transmission cooler there.