Nuggethead 420
Well-Known Member
- Joined
- September 2, 2003
- Messages
- 242
- Reaction score
- 0
- City, State
- Milwaukee, wi
- Year, Model & Trim Level
- 91 Eddie Bauer
Problem,
The engine idles rough after replacing the head gaskets push rods, and intake upper and lower gaskets. new spark plugs and wires.
Engine starts and dies right away when cold.
when you do get it running it idles low and rough.
When you unplug the mass flow air sensor it idles about 1500 rpms but dies when youopen the throttle wide.
I cannot figure out what to do.
Also the trans runs to 5000rpms before first shift when cold but then runs fine after that.
Any help whould be awsome.
Thanks
The engine idles rough after replacing the head gaskets push rods, and intake upper and lower gaskets. new spark plugs and wires.
Engine starts and dies right away when cold.
when you do get it running it idles low and rough.
When you unplug the mass flow air sensor it idles about 1500 rpms but dies when youopen the throttle wide.
I cannot figure out what to do.
Also the trans runs to 5000rpms before first shift when cold but then runs fine after that.
Any help whould be awsome.
Thanks