Mcneil Fiberglass Body sides install

[Smith463]

Hello, im looking into purchasing the mcneil 4 door fiberglass rear bulge fender kit for my 98 explorer but was wondering if anyone here has used the kit and how you went about mounting it. Pretty sure im going to convert my truck over to a baja style truck over the next year as i finally finished my mustang restoration. any advice or anyone thet can point me in the right direction would be greatly appreciated.

 

[410Fortune]

I put mcneil sides on my BII recently
Not the same vehicle, but mounting fiberglass sides would be similar
I used mounting tabs and urethane mounts from Autofab seen here

Fender Mount Kit 10 or more

Quantity Discount 10 or more fender mounts priced at $3.00 each, you may mix colors and quantities. For example 10 white and 6 Black is 16 total at $3 ea is $48.00. NOTE: Be Sure To Enter quantity tot

autofab.com

Stainless hardware too! I love AUTOFAB

Here is the thread where I mounted mine

410Fortune 1988 Ford Bronco II Eddie Bauer 4x4

Have you seen Joe Deitz Ranchero? I am sure its posted out there somewhere..... I saw it for about 20 seconds this summer when I was in CO for 4 days working on trucks at Brett's house, Joe drove past. That thing is so sweet! explorer 5.0 with 4r70w using Baumman /optishift controller now it has...

www.explorerforum.com

 

[Smith463]

Sick, that helps me a ton, i was hoping you didnt have to cut it up but it makes sense now, i have some serious considerations to make i think im going to dos omething to the front end no matter what but im not sure about the back yet.