OK I have made the decision that I am going to redo my SAS. I would like to do a radius arm setup, and hopefully use my current grand waggy axle.
So my question is does anyone know if the axle is wide enough to use the weld on wedges? Or will I have to get some builder brackets and modify them to weld on to the cast housing?
These are the wedges i was planning on using;
So my question is does anyone know if the axle is wide enough to use the weld on wedges? Or will I have to get some builder brackets and modify them to weld on to the cast housing?
These are the wedges i was planning on using;