seat belt anchor bolts

[VinnyBags]

The seat belt anchor bolt that attaches the passangerside second row shoulder harness to the floor snapped. Does anyone know what the torque screw size is for the bolt?

I also see the end of the screw in the wheel well, can I back out the part of the screw stuck in the theads by using awrench on the underside of the screw in the wheel well?

 

[esclamada]

it's either a T55 or T60, I just bought the whole set Harbor Freight ($10) In my case I have to use an impact to remove the bolt. I guess you can use a wrench on the other side but it's not that easy. The threads on the wheel well is rusted that you have to put PB-Blaster before tackling this job without an impact.

I have to remove the belt to remove the quarter panel when I was servicing my rear AC.



-----------------------------------------------------------
MY MOUNTY
http://www.facebook.com/diyfordexplorer/photos_albums

 

[JoshMcMadMac]

It should be a T50 torx.

 

[Foo]

Does anyone know what these should be torqued at when reinstalling?

Specifically the drivers side anchor bolt, that attaches the seatbelt to the floor.

 

[swshawaii]

T50 anchor bolts 30 ft/lbs. Some disagree, but I always use anti seize on fasteners going through the floor. Stripped Torx bolts = :fire:

I guess ALL seat belt bolts are 30 ft/lbs. Love how Ford has different names for the same parts. (Outboard safety belt retractor bolts)
https://www.scribd.com/doc/262501266/safety-belt-system-specifications-pdf