Torque setting for 4.0L cylinder head

[Vette76]

Hey guys. Looking for the numerical torque setting for the cylinder head bolts in a 4.0L V6.

The manual gives an initial setting and then directs you to turn another "90 degrees".

I can't believe that this is very precise, especially when I've always felt that getting the cylinder heads torqued evenly is one of the most important things. Not good when two different fluids meet each other.

Has any one done the math on what the exact torque settings are for these?

Thanks for any help.

 

[vipersinu2]

.

 

[andre 244]

there two 4.0 engine sohc or ohc
also don.t forget the 90 degree is fore new bolt
look at subaru engine torque 6 step some 7 here one more good on some eng
torque 90 degrees whit torque wrench if not between 65 to 75 lbs or start again
there go a gasket set lol what a joke

ps


french frog here