Lost vacuum mod pin, who has measurements?

explorer pilot · August 7, 2007

Yes somehow it didn't get in there. I was in quite a hurry to finish the job and arm was cut up. Can find it on the floor(was too impressed with how well the truck ran without ATF injection). Do any auto gurus have the dimensions. I'll fab one, but in the past I always had the original to copy and lengthen. '94 auto. Much thanks inadvance.

BrooklynBay · August 7, 2007

I don't know the exact size, but looking at these pictures from Glacier991's photo gallery, the pin sticks out just a little bit from the modulator: http://www.explorerforum.com/photopost/search.php?searchid=7231

CDW6212R · August 8, 2007

Ditto, I don't know how long they are supposed to be. I did run across my extra Chrysler pins though. When I did my first A4LD valve body it was suggested that I make the modulator pin 1/8" longer.

I have the pins in each of my A4LD's 1/8" longer than stock, it did help the 1/2 shift a hair in both. They were made by shortening a longer old Chrysler pin. Good luck,

Fordmandan87 · August 9, 2007

did u want my spare modulator to use or part out

explorer pilot · August 9, 2007

Thanks for the replys. After I found one in town $2.00 and got out drain pan for the change, guess what I found. Anyone need one I have an extra.

BrooklynBay · August 10, 2007

Where was the old one when you found it? So back to the original question. How long is it?

explorer pilot · August 13, 2007

Pin was in the drain pan. Stock pin is .16" Dia and 1.335" length.

CDW6212R · August 13, 2007

Cool, now find a longer one and make it 1.460" or so.

Lost vacuum mod pin, who has measurements?

explorer pilot

Member

BrooklynBay

Moderator & long time member.

CDW6212R

Hauls the mail.

Fordmandan87

Well-Known Member

explorer pilot

Member

BrooklynBay

Moderator & long time member.

explorer pilot

Member

CDW6212R

Hauls the mail.

Explorer Features

Explorer Features

Similar threads

Featured Content