I pulled off the left rear panel cover on my 2001 sport, and the box/code is not there. Just the seat belt roller thing. Any idea where the code is on the sport?
The original post in this thread shows the RAP/CSM location for the 2nd Generation 4-door Explorer.
For 2001~2003 Explorer Sport, Sport Trac and Ranger, the CSM module should be located in the dash above the HVAC plenum. You must remove the passenger airbag to access the module. The 5-digit keypad code will be stamped on the module label.
In my 01 sport, that was located behind the passenger airbag. All i had to do was lower the glovebox, removed the two bolts holding the airbag, slipped it out, then there were two other bolts holding the module in, which i removed and pulled the module out far enough to read my code. Very simple task....
The doors lock and unlock fine with the key pad on the drivers side door, but not with either of the remotes i have. Is the RAP fine and just the remotes are dead?
mine will not go in to program mode what now where do i go from here? HELP.
i have a 99 explorer
Did your vehicle come with remotes or were you trying to add them?
It had a remote when I bought it, but it died. Tried new batts, but nothing. the doors unlock using the code thats on the RAP module. Can the remotes themselves die?
can anyone tell me where to find the code for a lincoln navigator. it'll be the 1st generation body style. my stepdad was gonna take it to the dealership to get the keypad to work.
not to sure about it being on the same platform since its a whole lot bigger than the explorer. but i just found this thread and never realized the code was on the truck. check it out tomorrow.
Does the keypad work or is it just not illuminating? Did you check the fuses?